FreeBSD/Linux Kernel Cross Reference
sys/contrib/device-tree/Bindings/clock/hisi-crg.txt

     * HiSilicon Clock and Reset Generator(CRG)
     
     The CRG module provides clock and reset signals to various
     modules within the SoC.
     
     This binding uses the following bindings:
         Documentation/devicetree/bindings/clock/clock-bindings.txt
         Documentation/devicetree/bindings/reset/reset.txt
     
    Required Properties:
    
    - compatible: should be one of the following.
      - "hisilicon,hi3516cv300-crg"
      - "hisilicon,hi3516cv300-sysctrl"
      - "hisilicon,hi3519-crg"
      - "hisilicon,hi3798cv200-crg"
      - "hisilicon,hi3798cv200-sysctrl"
    
    - reg: physical base address of the controller and length of memory mapped
      region.
    
    - #clock-cells: should be 1.
    
    Each clock is assigned an identifier and client nodes use this identifier
    to specify the clock which they consume.
    
    All these identifier could be found in <dt-bindings/clock/hi3519-clock.h>.
    
    - #reset-cells: should be 2.
    
    A reset signal can be controlled by writing a bit register in the CRG module.
    The reset specifier consists of two cells. The first cell represents the
    register offset relative to the base address. The second cell represents the
    bit index in the register.
    
    Example: CRG nodes
    CRG: clock-reset-controller@12010000 {
            compatible = "hisilicon,hi3519-crg";
            reg = <0x12010000 0x10000>;
            #clock-cells = <1>;
            #reset-cells = <2>;
    };
    
    Example: consumer nodes
    i2c0: i2c@12110000 {
            compatible = "hisilicon,hi3519-i2c";
            reg = <0x12110000 0x1000>;
            clocks = <&CRG HI3519_I2C0_RST>;
            resets = <&CRG 0xe4 0>;
    };

Cache object: 3f9e51d98f2cee5ad36fba540061d1b0