FreeBSD/Linux Kernel Cross Reference
sys/dev/ic/sunscpalreg.h

     /*      $NetBSD: sunscpalreg.h,v 1.3 2008/04/28 20:23:51 martin Exp $   */
     
     /*-
      * Copyright (c) 2001 The NetBSD Foundation, Inc.
      * All rights reserved.
      *
      * This code is derived from software contributed to The NetBSD Foundation
      * by Matthew Fredette.
      *
     * Redistribution and use in source and binary forms, with or without
     * modification, are permitted provided that the following conditions
     * are met:
     * 1. Redistributions of source code must retain the above copyright
     *    notice, this list of conditions and the following disclaimer.
     * 2. Redistributions in binary form must reproduce the above copyright
     *    notice, this list of conditions and the following disclaimer in the
     *    documentation and/or other materials provided with the distribution.
     *
     * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
     * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
     * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
     * PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
     * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
     * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
     * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
     * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
     * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
     * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
     * POSSIBILITY OF SUCH DAMAGE.
     */
    
    /*
     * Macros for accessing the registers in the Sun "Sun-2" "sc"
     * PAL+logic sequencer chips.
     */
    
    /*
     * Interface Control Register.
     *
     * This register pretty much just reflects the state of the SCSI
     * bus, directly.  For example, the _COMMAND_DATA, _MESSAGE,
     * and _INPUT_OUTPUT bits and their values correspond directly
     * to SCSI bus signals.
     *
     * Note:
     *      (r)     indicates bit is read only.
     *      (rw)    indicates bit is read or write.
     */
    #define SUNSCPAL_ICR_PARITY_ERROR       0x8000  /* (r) parity error */
    #define SUNSCPAL_ICR_BUS_ERROR          0x4000  /* (r) bus error */
    #define SUNSCPAL_ICR_ODD_LENGTH         0x2000  /* (r) odd length */
    #define SUNSCPAL_ICR_INTERRUPT_REQUEST  0x1000  /* (r) interrupt request */
    #define SUNSCPAL_ICR_REQUEST            0x0800  /* (r) request */
    #define SUNSCPAL_ICR_MESSAGE            0x0400  /* (r) message */
    #define SUNSCPAL_ICR_COMMAND_DATA       0x0200  /* (r) 1=command, 0=data */
    #define SUNSCPAL_ICR_INPUT_OUTPUT       0x0100  /* (r) 1=input (initiator should read), 0=output */
    #define SUNSCPAL_ICR_PARITY             0x0080  /* (r) parity */
    #define SUNSCPAL_ICR_BUSY               0x0040  /* (r) busy */
    #define SUNSCPAL_ICR_SELECT             0x0020  /* (rw) select */
    #define SUNSCPAL_ICR_RESET              0x0010  /* (rw) reset */
    #define SUNSCPAL_ICR_PARITY_ENABLE      0x0008  /* (rw) enable parity */
    #define SUNSCPAL_ICR_WORD_MODE          0x0004  /* (rw) word mode */
    #define SUNSCPAL_ICR_DMA_ENABLE         0x0002  /* (rw) enable DMA */
    #define SUNSCPAL_ICR_INTERRUPT_ENABLE   0x0001  /* (rw) enable interrupts */
    
    #define SUNSCPAL_ICR_BITS       "\2\1INTEN\2DMAEN\3WM\4PAREN\5RESET\6SEL\7BSY\10PAR\11INPUT\12CMD\13MSG\14REQ\15INTRQ\16ODD\17BUSERR\20PARERR"
    
    /*
     * This chip keeps its DMA count with its bits flipped.  Normally, you
     * would just use the ~ operator everywhere.  However, apparently that
     * operator doesn't always work as you would expect, i.e.:
     *
     * #include <stdio.h>
     * int main() {
     *   unsigned short x;
     *   int y;
     *   x = 0;
     *   y = ~x;
     *   printf("%d\n", y);
     * }
     *
     * prints -1, not 65535.  So this macro does the bit-flipping
     * carefully for you.
     */
    #define SUNSCPAL_DMA_COUNT_FLIP(x) (((unsigned short) (x)) ^ 0xFFFF)

Cache object: b42095b3774d616a82f29b1132a3d9ae