FreeBSD/Linux Kernel Cross Reference
sys/dev/ic/wereg.h

     /*      $NetBSD: wereg.h,v 1.2 2001/07/04 11:14:10 jdolecek Exp $       */
     
     /*
      * National Semiconductor DS8390 NIC register definitions.
      *
      * Copyright (C) 1993, David Greenman.  This software may be used, modified,
      * copied, distributed, and sold, in both source and binary form provided that
      * the above copyright and these terms are retained.  Under no circumstances is
      * the author responsible for the proper functioning of this software, nor does
     * the author assume any responsibility for damages incurred with its use.
     */
    
    /*
     *              Definitions for Western digital/SMC WD80x3 series ASIC
     */
    
    /*
     * Memory Select Register (MSR)
     */
    #define WE_MSR  0
    
    /* next three definitions for Toshiba */
    #define WE_MSR_POW      0x02    /* 0 = power save, 1 = normal (R/W) */
    #define WE_MSR_BSY      0x04    /* gate array busy (R) */
    #define WE_MSR_LEN      0x20    /* 0 = 16-bit, 1 = 8-bit (R/W) */
    
    #define WE_MSR_ADDR     0x3f    /* Memory decode bits 18-13 */
    #define WE_MSR_MENB     0x40    /* Memory enable */
    #define WE_MSR_RST      0x80    /* Reset board */
    
    /*
     * Interface Configuration Register (ICR)
     */
    #define WE_ICR  1
    
    #define WE_ICR_16BIT    0x01    /* 16-bit interface */
    #define WE_ICR_OAR      0x02    /* select register (0=BIO 1=EAR) */
    #define WE_ICR_IR2      0x04    /* high order bit of encoded IRQ */
    #define WE_ICR_MSZ      0x08    /* memory size (0=8k 1=32k) */
    #define WE_ICR_RLA      0x10    /* recall LAN address */
    #define WE_ICR_RX7      0x20    /* recall all but i/o and LAN address */
    #define WE_ICR_RIO      0x40    /* recall i/o address */
    #define WE_ICR_STO      0x80    /* store to non-volatile memory */
    #ifdef TOSH_ETHER
    #define WE_ICR_MEM      0xe0    /* shared mem address A15-A13 (R/W) */
    #define WE_ICR_MSZ1     0x0f    /* memory size, 0x08 = 64K, 0x04 = 32K,
                                       0x02 = 16K, 0x01 = 8K */
                                    /* 64K can only be used if mem address
                                       above 1MB */
                                    /* IAR holds address A23-A16 (R/W) */
    #endif
    
    /*
     * IO Address Register (IAR)
     */
    #define WE_IAR  2
    
    /*
     * EEROM Address Register
     */
    #define WE_EAR  3
    
    /*
     * Interrupt Request Register (IRR)
     */
    #define WE_IRR  4
    
    #define WE_IRR_0WS      0x01    /* use 0 wait-states on 8 bit bus */
    #define WE_IRR_OUT1     0x02    /* WD83C584 pin 1 output */
    #define WE_IRR_OUT2     0x04    /* WD83C584 pin 2 output */
    #define WE_IRR_OUT3     0x08    /* WD83C584 pin 3 output */
    #define WE_IRR_FLASH    0x10    /* Flash RAM is in the ROM socket */
    
    /*
     * The three bits of the encoded IRQ are decoded as follows:
     *
     * IR2 IR1 IR0  IRQ
     *  0   0   0   2/9
     *  0   0   1   3
     *  0   1   0   5
     *  0   1   1   7
     *  1   0   0   10
     *  1   0   1   11
     *  1   1   0   15
     *  1   1   1   4
     */
    #define WE_IRR_IR0      0x20    /* bit 0 of encoded IRQ */
    #define WE_IRR_IR1      0x40    /* bit 1 of encoded IRQ */
    #define WE_IRR_IEN      0x80    /* Interrupt enable */
    
    /*
     * LA Address Register (LAAR)
     */
    #define WE_LAAR 5
    
    #define WE_LAAR_ADDRHI  0x1f    /* bits 23-19 of RAM address */
    #define WE_LAAR_0WS16   0x20    /* enable 0 wait-states on 16 bit bus */
    #define WE_LAAR_L16EN   0x40    /* enable 16-bit operation */
    #define WE_LAAR_M16EN   0x80    /* enable 16-bit memory access */
   
   /* i/o base offset to station address/card-ID PROM */
   #define WE_PROM 8
   
   /*
    *      83C790 specific registers
    */
   /*
    * Hardware Support Register (HWR) ('790)
    */
   #define WE790_HWR       4
   
   #define WE790_HWR_RST   0x10    /* hardware reset */
   #define WE790_HWR_LPRM  0x40    /* LAN PROM select */
   #define WE790_HWR_SWH   0x80    /* switch register set */
   
   /*
    * ICR790 Interrupt Control Register for the 83C790
    */
   #define WE790_ICR       6
   
   #define WE790_ICR_EIL   0x01    /* enable interrupts */
   
   /*
    * REV/IOPA Revision / I/O Pipe register for the 83C79X
    */
   #define WE790_REV       7
   
   #define WE790_REV_790   0x20
   #define WE790_REV_795   0x40
   
   /*
    * 79X RAM Address Register (RAR)
    *      Enabled with SWH bit=1 in HWR register
    */
   
   #define WE790_RAR       0x0b
   
   #define WE790_RAR_SZ8   0x00    /* 8k memory buffer */
   #define WE790_RAR_SZ16  0x10    /* 16k memory buffer */
   #define WE790_RAR_SZ32  0x20    /* 32k memory buffer */
   #define WE790_RAR_SZ64  0x30    /* 64k memory buffer */
   
   /*
    * General Control Register (GCR)
    * Enabled with SWH bit == 1 in HWR register
    */
   #define WE790_GCR       0x0d
   
   #define WE790_GCR_LIT   0x01    /* on for UTP */
   #define WE790_GCR_GPOUT 0x02    /* if BNC is enabled */
   #define WE790_GCR_IR0   0x04    /* bit 0 of encoded IRQ */
   #define WE790_GCR_IR1   0x08    /* bit 1 of encoded IRQ */
   #define WE790_GCR_ZWSEN 0x20    /* zero wait state enable */
   #define WE790_GCR_IR2   0x40    /* bit 2 of encoded IRQ */
   /*
    * The three bits of the encoded IRQ are decoded as follows:
    *
    * IR2 IR1 IR0  IRQ
    *  0   0   0   none
    *  0   0   1   9
    *  0   1   0   3
    *  0   1   1   5
    *  1   0   0   7
    *  1   0   1   10
    *  1   1   0   11
    *  1   1   1   15
    */
   
   /* i/o base offset to CARD ID */
   #define WE_CARD_ID      WE_PROM+6
   
   /* Board type codes in card ID */
   #define WE_TYPE_WD8003S         0x02
   #define WE_TYPE_WD8003E         0x03
   #define WE_TYPE_WD8013EBT       0x05
   #define WE_TYPE_TOSHIBA1        0x11    /* named PCETA1 */
   #define WE_TYPE_TOSHIBA2        0x12    /* named PCETA2 */
   #define WE_TYPE_TOSHIBA3        0x13    /* named PCETB */
   #define WE_TYPE_TOSHIBA4        0x14    /* named PCETC */
   #define WE_TYPE_WD8003W         0x24
   #define WE_TYPE_WD8003EB        0x25
   #define WE_TYPE_WD8013W         0x26
   #define WE_TYPE_WD8013EP        0x27
   #define WE_TYPE_WD8013WC        0x28
   #define WE_TYPE_WD8013EPC       0x29
   #define WE_TYPE_SMC8216T        0x2a
   #define WE_TYPE_SMC8216C        0x2b
   #define WE_TYPE_WD8013EBP       0x2c
   
   /* Bit definitions in card ID */
   #define WE_REV_MASK             0x1f    /* Revision mask */
   #define WE_SOFTCONFIG           0x20    /* Soft config */
   #define WE_LARGERAM             0x40    /* Large RAM */
   #define WE_MICROCHANEL          0x80    /* Microchannel bus (vs. isa) */
   
   /*
    * Checksum total.  All 8 bytes in station address PROM will add up to this.
    */
   #ifdef TOSH_ETHER
   #define WE_ROM_CHECKSUM_TOTAL   0xA5
   #else
   #define WE_ROM_CHECKSUM_TOTAL   0xFF
   #endif
   
   #define WE_NIC_OFFSET           0x10    /* I/O base offset to NIC */
   #define WE_ASIC_OFFSET          0       /* I/O base offset to ASIC */
   #define WE_NIC_NPORTS           16
   #define WE_ASIC_NPORTS          16
   #define WE_NPORTS               (WE_NIC_NPORTS + WE_ASIC_NPORTS)
   
   #define WE_PAGE_OFFSET  0       /* page offset for NIC access to mem */

Cache object: 75df2310058b7554f48d7e329e3ecd01