FreeBSD/Linux Kernel Cross Reference
sys/mips/conf/AP135
1 #
2 # AP135 - the QCA955x SoC reference design
3 #
4 # This contains a QCA9558 MIPS74k SoC with on-board 3x3 2GHz wifi,
5 # 128MiB RAM, an AR8327 5-port gigabit ethernet switch and
6 # a QCA 11ac 5GHz AP NIC.
7 #
8 # The to things not currently support are the QCA 11ac NIC and
9 # PCIe host controllers - there's two of them, and the existing
10 # PCIe code here doesn't support that just yet.
11 #
12 # $FreeBSD$
13 #
14
15 #NO_UNIVERSE
16
17 # Include the default QCA955x parameters
18 include "QCA955X_BASE"
19
20 ident AP135
21
22 # Override hints with board values
23 hints "AP135.hints"
24
25 # Force the board memory - the base AP135 has 128MB RAM
26 options AR71XX_REALMEM=(128*1024*1024)
27
28 # i2c GPIO bus
29 #device gpioiic
30 #device iicbb
31 #device iicbus
32 #device iic
33
34 # Options required for miiproxy and mdiobus
35 options ARGE_MDIO # Export an MDIO bus separate from arge
36 device miiproxy # MDIO bus <-> MII PHY rendezvous
37
38 device etherswitch
39 device arswitch
40
41 # read MSDOS formatted disks - USB
42 #options MSDOSFS
43
44 # Enable the uboot environment stuff rather then the
45 # redboot stuff.
46 options AR71XX_ENV_UBOOT
47
48 # uzip - to boot natively from flash
49 device xz
50 options GEOM_UZIP
51
52 # Used for the static uboot partition map
53 device geom_map
54
55 # yes, this board has a PCIe connected atheros device
56 # add ath_pci so it can at least attach things when there's a
57 # ath(4) in there, rather than the 11ac chip we don't support.
58 device pci
59 device qca955x_pci
60
61 device ath_pci
62 options AR71XX_ATH_EEPROM
63 device firmware # Used by the above
64 options ATH_EEPROM_FIRMWARE
65
66 # Boot off of the rootfs, as defined in the geom_map setup.
67 options ROOTDEVNAME=\"ufs:map/rootfs.uzip\"
68
69 # Default to accept
70 options IPFIREWALL_DEFAULT_TO_ACCEPT
Cache object: 968ee2595b00cf103c0ace0867b5a850
|