1 #
2 # Specific board setup for the Picostation M2 HP board.
3 #
4 # This board has the following hardware:
5 #
6 # + AR7241 CPU SoC
7 # + AR9287 Wifi
8 # + Integrated switch (XXX speed?)
9 # + 8MB flash
10 # + 32MB RAM
11 # + uboot environment
12
13 # $FreeBSD: releng/10.3/sys/mips/conf/PICOSTATION_M2HP 266331 2014-05-17 17:34:37Z ian $
14
15 include "AR724X_BASE"
16 ident "PICOSTATION_M2HP"
17 hints "PICOSTATION_M2HP.hints"
18
19 options AR71XX_REALMEM=32*1024*1024
20
21 options AR71XX_ENV_UBOOT
22
23 # Limit inlines
24 makeoptions INLINE_LIMIT=768
25
26 # We bite the performance overhead for now; the kernel won't
27 # fit if the mutexes are inlined.
28 options MUTEX_NOINLINE
29 options RWLOCK_NOINLINE
30 options SX_NOINLINE
31
32 # There's no need to enable swapping on this platform.
33 options NO_SWAPPING
34
35 # For DOS - enable if required
36 # options MSDOSFS
37
38 # uncompress - to boot read-only lzma natively from flash
39 device geom_uncompress
40 options GEOM_UNCOMPRESS
41 options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
42
43 # Not enough space for these..
44 nooptions INVARIANTS
45 nooptions INVARIANT_SUPPORT
46 nooptions WITNESS
47 nooptions WITNESS_SKIPSPIN
48 nooptions DEBUG_REDZONE
49 nooptions DEBUG_MEMGUARD
50
51 # Used for the static uboot partition map
52 device geom_map
53
54 # Options needed for the EEPROM based calibration/PCI configuration data.
55 options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
56 options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
57 device firmware # Used by the above
58
59 # Options required for miiproxy and mdiobus
60 options ARGE_MDIO # Export an MDIO bus separate from arge
61 device miiproxy # MDIO bus <-> MII PHY rendezvous
62
63 device etherswitch
64 device arswitch
65
66 # Enable GPIO
67 device gpio
68 device gpioled
Cache object: 26844ecab22146177c80e2008cd53023
|