1 #
2 # Specific board setup for the Picostation M2 HP board.
3 #
4 # This board has the following hardware:
5 #
6 # + AR7241 CPU SoC
7 # + AR9287 Wifi
8 # + Integrated switch (XXX speed?)
9 # + 8MB flash
10 # + 32MB RAM
11 # + uboot environment
12
13 # $FreeBSD$
14
15 #NO_UNIVERSE
16
17 include "AR724X_BASE"
18 ident "PICOSTATION_M2HP"
19 hints "PICOSTATION_M2HP.hints"
20
21 options AR71XX_REALMEM=32*1024*1024
22
23 options AR71XX_ENV_UBOOT
24
25 # Limit inlines
26 makeoptions INLINE_LIMIT=768
27
28 # We bite the performance overhead for now; the kernel won't
29 # fit if the mutexes are inlined.
30 options MUTEX_NOINLINE
31 options RWLOCK_NOINLINE
32 options SX_NOINLINE
33
34 # There's no need to enable swapping on this platform.
35 options NO_SWAPPING
36
37 # For DOS - enable if required
38 # options MSDOSFS
39
40 # uncompress - to boot read-only lzma natively from flash
41 device xz
42 options GEOM_UZIP
43 options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\"
44
45 # Not enough space for these..
46 nooptions INVARIANTS
47 nooptions INVARIANT_SUPPORT
48 nooptions WITNESS
49 nooptions WITNESS_SKIPSPIN
50 nooptions DEBUG_REDZONE
51 nooptions DEBUG_MEMGUARD
52
53 # Used for the static uboot partition map
54 device geom_map
55
56 # Options needed for the EEPROM based calibration/PCI configuration data.
57 options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
58 options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
59 device firmware # Used by the above
60
61 # Options required for miiproxy and mdiobus
62 options ARGE_MDIO # Export an MDIO bus separate from arge
63 device miiproxy # MDIO bus <-> MII PHY rendezvous
64
65 device etherswitch
66 device arswitch
67
68 # Enable GPIO
69 device gpio
70 device gpioled
Cache object: 083bdbfdf6e29bc606a539119b0847cc
|